Plumbing service
Drain cleaning for Etobicoke homes
A slow drain tells you something is wrong, not what. We pick the cable head to match the pipe, clear the stoppage, then run water hard enough to prove the line carries a full load before we pack up.
- Typical fixtures: Kitchen sinks, vanities, tubs, laundry tubs, floor drains, main stacks
- Tools on the truck: Drum auger, sectional machine, small-line jetter, push camera
- Usual pipe in older Etobicoke homes: Cast iron stacks, galvanized branches, clay or cast iron to the street
- Proof of clearing: Full-flow test, camera footage on request
- Licensed, insured trade work (details confirmed when you call)
- Diagnosis before anything is cut
- Emergency calls taken
- Etobicoke and the west end
At a glance
- Typical fixtures
- Kitchen sinks, vanities, tubs, laundry tubs, floor drains, main stacks
- Tools on the truck
- Drum auger, sectional machine, small-line jetter, push camera
- Usual pipe in older Etobicoke homes
- Cast iron stacks, galvanized branches, clay or cast iron to the street
- Proof of clearing
- Full-flow test, camera footage on request
Picking the right tool for the line
A two-inch kitchen branch packed with grease needs a different head than a four-inch main with root hairs at a clay joint. We start with the smallest machine that will reach the blockage, because an oversized cable can kink in a tight trap arm and scar old cast iron from the inside.
- Where grease has glazed the pipe wall, the cable just bores a narrow tunnel through the fat.
- That is where a jetter earns its keep: the rear-facing nozzles scour the full circumference and flush the debris down to the main, so the drain is open rather than just poked.
What usually causes the clog
In bathrooms it is hair wound around the stopper linkage and soap scum that binds it into a felt mat. In kitchens it is fat that went down warm and set solid a few metres along, often right where the pipe turns down into the basement ceiling.
- Floor drains in post-war Etobicoke basements collect laundry lint, sand from the weeping tiles and sometimes roots coming in through the old clay connection.
- Each one tells us something different, so we look at what comes back on the cable head instead of throwing it away.
After the drain runs again
We run each cleared fixture for several minutes and watch the next fixture down the line for gurgling, which would mean a vent or a second partial blockage. If one fixture has stopped up more than twice in a year, we recommend a camera pass so you stop paying for an identical clearing again next season.
- You get a straight answer on whether the pipe itself is sound.
- A belly in a basement line, a cracked hub or a collapsed section of clay will keep catching debris no matter how often it is cleaned.
Signs to watch for
- Water standing in the tub several minutes after a shower
- Gurgling from the sink when the washing machine drains
- A sewer smell near the basement floor drain
- More than one fixture slowing at the same time
- Water appearing at the basement grate whenever a toilet upstairs flushes
How the job runs
Listen first
You describe which fixtures are slow and since when; that often points to branch or main before we arrive.
Open the access
We use the cleanout or pull the trap so the cable never has to be forced through a tight bend.
Clear and inspect
The head is pulled back and examined, and a camera goes in where repeat trouble is likely.
Prove the flow
Fixtures are run together to load the line, and the work area is wiped down and left dry.